Mini-Telemaster ARF

47" wingspan, 32-1/2" long, 329 sq. in. wing area, 23 oz. flying weight. Up until now, if you wanted a Mini-Telemaster, you had to build one yourself. Not any longer. Mini-Telemaster is now offered as an ARF. Airplane is pre-built and covered. The hard building has been done for you. Assembly takes only about 3 hours and consists of gluing the wing halves together, installing the tail parts to the fuselage and installing the radio equipment. The main landing gear is pre-bent wire and the tailwheel is steerable. When it comes to flying, Mini-Telemaster flies like a Telemaster. Smooth, responsive, and predictable; it still has all of the gentle handling and slow flight characteristics of the larger Telemaster airplanes. The difference is it can be flown in a much smaller area. For 3 Channels: Elevator, Rudder and Throttle.

Mini Telemaster PDF Instruction Manual

HLA114W Main Wing with Ailerons for Mini-Telemaster ..... $ 32.90 ESTIMATED ARRIVAL 12/26/08 - Please Preorder Now A simple direct replacement wing with strip ailerons, installs on your Mini-Telemaster with no modifications. The wing is the same size and area as the original wing. The dihedral has been reduced for use with ailerons. Comes in two panels, each pre-covered with the ailerons pre-hinged and torque rods in place. Wing joiner must be epoxied together and then the wing halves must be glued together with epoxy. An aileron servo must be installed (HS-81 servo not included) and connected to the aileron torque rods with the included hardware. 4-Channel radio required for this application. Decal set included.

Here's how it comes out of the box!

Check out the of the Mini Telemaster ARF!