Pushrods,
Connectors, Control Surface Linkages
|
Pushrods,
Connectors, Control Surface Linkages
|
| Home | Electric Flight | Other Hardware | |
|
Tiny hardware for Slow and Park Flyers!
|
|
These
very lightweight hardware items are small sized and lightweight for
Slow and Park Flyer models. |
|
 |
|
|
|
|
 |
|
|
|
|
 |
|
|
|
|
 |
|
|
|
|
 |
|
|
|
|
 |
|
|
|
|
 |
|
|
|
|
 |
|
 |
|
|
|
|
 |
|
Complete Flexcable Pushrods --
Everything included!  |
|
|
|
|
|
Very special flexible COMPLETE pushrod for Mini and Electric Flight airplanes Two 36" long complete pushrods that use tiny 1/32" music wire for small models like park and indoor flyers. The control surface end has a factory made z-bend. The servo end is secured using the included micro pushrod connectors. VERY precise, VERY lightweight, VERY easy to use. |
|
|
|
|
Best
general purpose COMPLETE Pushrod System we’ve seen!
 |
Two
36" long complete pushrods that use tiny 1/32" music wire
inside special slippery plastic tube, which is inside a larger plastic
tube. The outside tube is only 1/8" diameter. But this pushrod
will control ANY size model airplane because of the inner music wire
stiffener. Included are 4 very fine threaded couplers (for PRECISE adjustment
of the clevises) and two of these threaded couplers come already attached
to the pushrod ends. Solder or crimp the other 2 threaded couplers to
the inner pushrods and screw on the high quality Kavan metal clevises
(4 included.) VERY precise, VERY lightweight, VERY easy to use. |
|
|
|
|
The
least friction of any pushrod system.
 |
Ready-made
pushrod with attached threaded coupler, 2mm threaded V-link and Hobby
Lobby Pushrod Connector. There is a microscopic "bumpy" surface
on the inner tube. This makes the inner tube nearly frictionless as
it moves inside the outer rube. Moisture does not increase the friction
so this is also good for boats and amphibious planes. There is less
than a .03% change in length with a 100 degree temperature change. HLH605
has a stiffener wire inside the inner tube. Easy to use: cut to length
and connect the inner tube to the servo wheel or arm using the included
Pushrod Connector. |
|
|
|
|
Joins
2 pushrods to 1 as on a split elevator.
 |
A machined fitting that
is about 1/2" long, in which are three holes for pushrods and holes
for Allen set screws. It can be used for such linkages as a single pushrod
from a servo connected to split elevators, or to flaps, or from dual
servos to a boat rudder. |
|
|
|
|
The
best way we’ve seen to bring a |
Puts an end to slop
and backlash caused by running a bent wire pushrod linkage through
a fuselage. Use one for rudder pushrod, one for elevator. Simple to
install: it also prevents those big ugly wallowed-out exit slots that
your receiver could fall through. |
Phone: 1-866-WE-FLY-RC (1-866-933-5972)
Fax: 615-377-6948
Copyright © 1996-2008 Hobby Lobby International, Inc. All Rights Reserved.
