![]() |
Electronic Test Equipment for RC Hobbies
|
| Home | Electric Flight | |
Never crash another plane due to a low receiver battery |
|
![]() |
Reads input voltages from 4 to 18 volts. By checking your receiver battery under load, weak batteries or undercharged batteries can be detected prior to the loss of your model. Detector will check batteries under 1/2A, 1A, or 1-1/2A loads depending on which button is depressed. Readout is on a large clear digital screen. Unit is reverse polarity protected. Use with Nicad, NiMH, Li-Ion and Li-Poly cells. |
Test and center your servos before you install them |
|
![]() |
Tiny 1-3/8 x 7/16 x 7/8", 8 grams. Servo adjuster allows you to connect 1 or 2 servos for centering or testing without the use of a receiver and transmitter. Connect any 4-5 cell receiver pack for power, plug in your servo(s), rotate the knob to test the travel then return the knob to the middle to center your servos. |
Checks voltage of 4-10 cell NiCad/NiMH or 1-3 LiPo packs |
|
![]() |
About 2-1/4 x 1-5/8 x 5/8", 1.3 oz., Large easy-to-read 3/8" LCD display indicates voltage of any battery pack 4-13 Volts DC instantly. Use with 4-10 cell NiCad and NiMH packs or 1-3 LiPo cells. Accurately check the voltage of your receiver pack before you fly. |
Extremely accurate temperature readings - instantly! |
|
![]() |
Approximately 3-1/4" long x 3/4" dia. Extend the life of your LiPo batteries, speed controls and motors by checking the temperature after flights making sure to operate them within the manufacturers recommended temperature ranges. This is a non-contact infrared thermometer, just aim the unit at the target and press the measure button to display the surface temperature. The measurement range is from –27.4 to 428 degrees F (-33 to 220 degrees C) with an accuracy of +/- 2%. Compact, comes with pocket clip and batteries. Auto shut-off after 15 seconds. |
Detects slightest breeze from any direction! |
|
|
|
Measure and improve performance of your electric flight system! |
|
![]() |
Both: 4-1/16 x 2-3/16 x 15/16", about 4 oz. Measure your motor's and battery's Volts (to 60V), Amps (to 100A), Watts (up to 6000), Amp-Hours (up to 9.999AH), and Watt-Hours (up to 999.9WH). Plug in Power Analyzer between your battery and motor controller to measure your system's performance. Easy to use with good instructions. Power Analyzer PLUS II can be connected to your computer's USB port with the included interface cable and its software (on CD). All of your tests can be saved and graphed on your computer. Track the changes in battery packs over time or optimize the prop and battery selection for your next plane. (Photo shows Power Analyzer Plus. Cable and CD are only included with this version.) Units come without connectors; order ones that match your systems. |
Cart | Home | E-Flight Accessories | Glow Accessories | Product Index | Catalog | Contact Us
Phone: 1-866-WE-FLY-RC (1-866-933-5972)
Fax: 615-377-6948
Copyright © 1996-2008 Hobby Lobby International, Inc. All Rights Reserved.